Leg Tube Dimensions and Pin Hole Diameter of etrailer Jack # TJD-5000S
Published 03/01/2023
Question:
What is the size of the leg tube and what size are the holes?
asked by: Darren N
1
Helpful Expert Reply:
The tube width of the drop leg that comes with the etrailer jack # TJD-5000S that you referenced is 1-3/4 inch square and the diameter of the pin holes is 5/8 inch.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Sidewind Jack
- 2001 - 3000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: What is Outer Tube Diameter of Trailer Valet Jack # TV57ZR
- Q&A: What is Overall Height of etrailer Jack # e34RV When Fully Retracted
- Q&A: Replacement for a Triple Vision Backup Camera and Monitor
- Q&A: Need Replacement For UFP PG1090 Actuator On Magic Tilt Single Axle Trailer
- Q&A: Timbren SES for 2021 Nissan Frontier Hauling Commercial Mower and Towing Utility Trailer
- Q&A: Can Spacers Be Added to Timbren SES To Make Smaller Gap
- Q&A: Axle Hub That Uses Bearings JM511946 and JM205149, Race JM511910 and JM205110
- Article: Trailer Lighting Requirements
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Jacks