How to Wire The Brake Buddy Stealth Brake Controller To A 2016 Coachmen Encounter 37LS MH

Updated 02/14/2023 | Published 02/13/2023

Products Featured in This Question

(28)

$27.73

Question:

I bought a brake buddy brake controller 39530 and i need some help with wiring it to my 2016 Coachmen Encounter 37ls . I found prewiring for brake controller thats labeled Brown - Illumination DK Blue -trailer elec brake feed Red- Trailer BRAKE control feed White- ground LT Green-Stop Lamp feed to Brake control. And on the brake controller Blue- Brake Black-Battery white - Ground Red- Stop I need to know what wires get connected together, Could you help me out, much appreciated since i bought everything for flat towing from you. thanks

asked by: William J

Helpful Expert Reply:

Sure, for your Brake Buddy Stealth Supplemental Braking System # HM39530, you are going to want to connect the:

- Blue Wire - To your vehicle's 7-way connector, and will tell the brakes to activate.

- White Wire - Will get spliced into your vehicle's existing wiring that runs to your vehicle's negative battery post.

- Black Wire - Will get spliced into your existing wire going to the 20 amp circuit breaker or in-line fuse to the positive terminal on your motorhomes battery.

-Red Wire - Will be spliced into the existing wire going to the cold side of your motorhome's stop light switch, which is located by the brake pedal.

If you're unsure on which side is the cold side, you can press the brake pedal and use a circuit tester # PTW2992 to find which wire powers your motorhome's stop lamps.

If you go to around the 20 minute mark in the attached install video you can see one of our techs going over how to do this as well.

I've also attached a wiring diagram for the all-in-one connector for you to check out.