Troubleshooting LED Utility Lights Working When Ignition Is On But Turning Off After Starting
Published 01/18/2023
Question:
I replaced all the lights on my utility with led lights, with the ignition on all lights work great. When I start the engine none of the lights work any suggestions?
asked by: David U
0
Expert Reply:
It sounds like some sort of ignition issue in the wiring. You will most likely need to have this checked at a service center for them to determine if your ignition switch may need replaced or if there is an issue with the ECU.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Sealed, 4" Round, LED Trailer Stop/Turn/Tail Light, 3-Function, 10 Diode - Red w/ Clear Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement for Haulmark # 900200 Fender Marker Light on 10 x 5 Enclosed Trailer
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Q&A: Replacement For Dometic AC 59516.331
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How to Identify Capacity of Dexter Axle by Measuring it
- Q&A: Replacement Shock for Dexter Axle 052-003-00
- Q&A: Replacement Hardware List for the B&W Turnoverball Gooseneck Hitch
- Q&A: Looking For Replacement Marker Light SAE A PC2 DOT 17 For A 2022 Surveyor Legend
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: How to Mount a Truck Bed Camper