How Does Optronics Clearance Light MC58RB Mount and Ground
Published 01/17/2023
Question:
Hello, I need to replace some surface mount marker lights on my stock trailer. The current ones are 2.5 surface mount with the grounding occurring with the rivets that connect it to the trailer. I am looking at these, but I cant tell the mounting mechanism or the grounding mechanism. Can you clarify for me? I need two red and two amber. Kind regards,
asked by: John M
Expert Reply:
To mount the Optronics clearance light part # MC58RB you'll remove the lens of the assembly and run the hardware through the holes in the back of the assembly. This grounds through the mounting hardware as well. So you run power to the black wire and then once mounted it is grounded.
Product Page this Question was Asked From
2-1/2" Round Trailer Clearance and Side Marker Light, Surface Mount - Red
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement for Kwikee Step Motor 1101423
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Torque Specification for Lugs Nuts on 5/8-Inch Stud on Dexter Hub
- Q&A: Replacement 2-1/2 Inch Red and Amber Clearance Lights for 2018 Kodiak Travel Trailer
- Q&A: Replacement Parts for Lippert RV Steps 171317
- Q&A: Replacement Electric Folding Steps For Lippert LCI 128980 Coachstep
- Q&A: Replacement Steps for Lippert 171317
- Q&A: Recommended Replacement Marker Lights For a Vintage Trailer With 2-1/2" Round Lights
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: My Trailer Hitch Doesn't Fit
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups