Recommended Wiring For 10 LED Side Marker Lights On 23' RV Trailer
Published 01/13/2023
Products Featured in This Question
Question:
What size gauge wire for 10 rv marker lights. 23 ft shell with 5 markers on front and 5 on the rear.
asked by: Jack M
Helpful Expert Reply:
I recommend using the 18-Gauge 2-Wire Bonded Wire # SWC97FR for installing 10 of the LED Trailer Side Marker Lights # MCL32ABB on your 23' shell. While the 18 gauge wire is larger than you need for the very low amperage of these lights it is not as delicate as the thinner wire and less likely to become damaged on your RV. The wire is sold per foot allowing you to get what you need.
Product Page this Question was Asked From
LED Trailer Clearance or Side Marker Light w/ Reflex Reflector- 3 Diodes - Black Base - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 2W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Replacement Roof Vent Lid for Dexter Roof Vent Serial Number VE0108
- Q&A: Recommended LCD Single Zone Thermostat for Dometic RV Air Conditioners
- Q&A: Replacement Mounting Bracket for a GloLight Thinline LED Marker Light MCL165AB
- Q&A: Demco Base Plate Kit that Fits 2018 Jeep Wrangler Rubicon
- Q&A: Looking For Replacement Marker Light SAE A PC2 DOT 17 For A 2022 Surveyor Legend
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Marker Lights for Bargman 552 on 1989 Pacer Arrow RV
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Wire an Electric Winch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)