How To Remove Lens For Peterson Incandescent Square Combination Lights For A Bulb Replacement
Updated 01/03/2023 | Published 01/01/2023
Products Featured in This Question
Question:
There are no screws holding the lense in. It appears to pop out off but I don’t want to break the lens trying. Again there are no screw holding it on
asked by: Bryan N
Expert Reply:
The Replacement Stop/Tail Red Lens for Peterson Incandescent Square Combination Tail Lights # 440-15R you mention should be secured to the light housing with 4 screws.
since you're staring that there are no screws holding the lens into the housing, I suggest taking a flat head screwdriver like what's included in the kit # PT32VR to gently pry each corner up.
I recommend starting on the upper right hand side and work your way clockwise, gently prying up.
If you're still unable to free the lens, don't hesitate to come back and we can try other options.
Product Page this Question was Asked From
Replacement Stop/Tail Red Lens for Peterson Incandescent Square Combination Tail Lights
- Accessories and Parts
- Trailer Lights
- Light Lenses
- 4-1/2 Inch Wide
- 4-1/2 Inch Long
- Square
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of 2" Long 1/2" Wheel Stud With 0.56" Spline
- Q&A: Possible Light Replacement For Monarch 5129 On 1977 Great Divide Trailer
- Q&A: Replacement Kwikee 909506000 Controle Module
- Q&A: Replacement of Norcold 1200LRIM with Everchill # WAY44FR
- Q&A: Is 440-15R The Correct Replacement Lens for Monarch 5124 Tail Light
- Q&A: Replacement Lens for Optronics ST60RS / ST60RB
- Q&A: Can E-Track be Installed in Car Hauler for Multiple Car Widths
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: Best Landing Gear
- Article: Trailer Jacks
- Article: How to Measure for Trailer Hitch Drop
- Article: Troubleshooting 4 and 5-Way Wiring Installations