What Size Thread Tap to Clean Out Weld Nuts of 2003 Honda Odyssey for Curt Hitch
Updated 01/03/2023 | Published 01/01/2023
Question:
The weld nuts on my Honda are bad! What size tap should I use to chase the threads to clean them out? The wire brush is not the right tool for this job
asked by: Richard A
0
Expert Reply:
The bolts of the Curt hitch part # C12031 that install in factory weldnuts are M12 -1.25x35 mm so the correct tap would be M12x1.25. The other size bolts that come with this hitch install with included nuts.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Hitch for VelociRAX 5 Bike Rack on 2012 Honda Odyssey
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Trailer Hitch Receiver for 2004 Honda Odyssey With 7-Bike Bike Rack
- Q&A: Recommended Hitch with Best Ground Clearance for 2013 Honda Odyssey
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Should The Air Lift Air Helper Springs Have Some Sort Of Spacer When Installed 2012 Honda Odyssey?
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Q&A: Which Trailer Hitch For a 2014 Honda Odyssey Offers the Best Ground Clearance
- Q&A: Recommended Trailer Hitch And Wiring For 2011 Honda Odyssey
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)