Where is the Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs Made
Published 12/08/2022
Question:
I recently featured one of your products on my youtube channel and I want to know if the product is made in the USA. It was the weld on trailer stabilizer.
asked by: Mark A
0
Expert Reply:
The Square Drop Leg Stabilizer Jack part # SJ-R208 is made overseas but it does have a warranty so if there were any issues with this product you'd be covered. That said, there really isn't much that could fail on the stabilizer so how it's attached to the trailer is likely going to be the weak point. Unfortunately, we don't offer any domestically made stabilizer jacks in this style.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs - Qty 1
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 1001 - 2000 lbs
- Manual Jack
- 18 Inch Lift
- Weld-On
- 1 Jack
- etrailer
more information >
Continue Researching
- Q&A: What Hitch Extension Is Best For 2021 Chevy Silverado LT With Lance Truck Camper?
- Q&A: Recommended Flatbed Cargo Trailer Stabilizer Leg for Rear of Trailer
- Q&A: Do You Carry The Lippert 7 Quart Vertical Pump Assembly 731445?
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Article: Trailer Lighting Requirements
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Q&A: Replacement Rod and Nut for a Bulldog 12,000 lb Trailer Jack
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft