Replacement L-Pin for 1,000 lb Tongue Weight Fastway e2 Weight Distribution System
Updated 11/25/2022 | Published 11/24/2022
Question:
I need replacement of my L-Pin for Fastway e2 Weight Distribution System and I found this Item # FA92-03-9460. but I am not sure if the same size. my sway bar say 1000lbs . with pin measurement : width 1.5cm x deep 1.5 cm height 8cm . my question is, are this two the same or give me recomendation. Thanks.
asked by: Alvin
0
Expert Reply:
Thanks for reaching out!
It sounds like you have the 1,000 TW/10,000 tow system so you need the L-Pin # FA92-03-9205 for your application.
Attached are review videos of each for you to check out.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Replacement L-Pin for Fastway e2 Weight Distribution Systems
- Accessories and Parts
- Weight Distribution Hitch
- Pins and Clips
- e2
- Fastway
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Replacement L-Pin for Fastway e2 Weight Distribution Systems
- Q&A: What Are The Dimensions Of The Replacement L-Pin FA92-03-9205?
- Q&A: Can Door Be Replaced On Mighty Cord Replacement RV Power Inlet
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: What Replacement L-Pins Will Work with My Fastway E2 Weight Distribution Hitch with Flat End Springs
- Q&A: Replacement L-Pins for Fastway e2 Weight Distribution Systems
- Q&A: Correct Replacement Frame Brackets for a 6K Equal-i-zer WDS
- Q&A: How Does Breakaway Switch Connect to Brake Buddy Classic 3 Braking System
- Q&A: How to Measure to Find Weight Distribution Shank with the Right Amount of Drop to Tow Trailer Level
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Anti-Rattle Devices
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: How to Raise Your Travel Trailer Height
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Replace an RV Roof Vent Cover