Availability of Demco Trailer Coupler DM12688-95

Question

Question:

I am trying to fin a Demco 12688xx coupler is this something you can get

asked by: Richard B

0

Expert Reply:

Yes we do carry the Demco Trailer Coupler part # DM12688-95 that you are looking for. This is an adjustable channel mount eZ latch coupler for a 2 inch ball that has a 10k capacity.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hello David, thanks for reaching out. It is possible to switch your trailer over to a lunette ring/pintle hitch system. Basically you will need to replace your current A-frame coupler with a channel coupler like part #LR76VR. This will allow you to…

view full answer...

Answer 4

The Demco #DM12688-95 you've looked at would be a good choice. The 2 inch channel mount coupler is compatible with a 3 inch channel, and has bolt spacing of 2 inches on center. Demco is known for high quality products, you'll get years of…

view full answer...

Answer 5

Hey Wes, the Dexter Hinge Kit part #DX53CR doesn't have a specific weight rating due to the nature of it's design. As long as the trailer with the 3 inch by 4 inch frame isn't exceeding it's capacity this hinge kit once installed…

view full answer...

Answer 6

The upper holes for the Buyers Products 45 Ton 4-Hole Air Compensated Pintle Hook #337P45AC4 are spaced 5-1/4" on center. The lower holes are spaced 6-1/2" on center. The distance from the upper holes to lower holes are spaced 3" on…

view full answer...

Answer 7

I went out to our warehouse and measured the Buyers Products 45 Ton Pintle Hook #337PH45 for you. The mounting platform where the holes are drilled, has a thickness of 0.7 inches.

view full answer...

Answer 8

No, not intentionally. The only way the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers item #RM-2460-2570 would increase the ride height is if your current suspension is extremely old and worn out. Even then it won't be…

view full answer...

Answer 9

With the Grech Strada RV not really being that large you can just mount the repeater for the TST TPMS Internal Tire Sensors #TST-507-INT-6-C somewhere in the engine bay. A couple of self-tapping screws will easily mount this to an open space.…

view full answer...

Availability of Demco Trailer Coupler DM12688-95

Product Page this Question was Asked From

Continue Researching