Replacement Lid for Dometic FV1250 Roof Vent

Question

Question:

I have a Dometic FV1250 in my camper. The FVK1020-19 hinge screw holes align perfectly, but the lifting plate is about 1/2 inch off. I cannot figure out what dome/cover to buy. Can you? Thanks!

asked by: Andy H

0

Expert Reply:

Thank you for reaching out and providing your photos!

The correct replacement lid for your Dometic FV1250 roof vent is the Replacement Flat Lid for Dometic Fan-Tastic Roof Vent - Smoke # DMC66FR which I confirmed with my contact at Dometic.

expert reply by: Jon G

0

Dometic FV1250 Roof Vent
(click to enlarge)

Dometic FV1250 Inside
(click to enlarge)

Dometic FV1250 Sticker
(click to enlarge)

Answer 1

P.O.L is actually and abbreviation for Prest-O-Lite, for the company that first produced the valve. This style of connector you will tighten the connector of the regulator pigtail by turning the fitting counter-clockwise, and you usually need to use…

view full answer...

Answer 2

No, there's no problem with having an O-ring on the end of your POL fitting like the Propane Hose - POL Pigtail x 1/4" Male Inverted Flare - 20" #37207-30625. The O-ring is going to help eliminate the odor you're smelling by helping…

view full answer...

Answer 3

It sounds like you need the Replacement Dome for Fan-Tastic Vent RV Roof Vents, #FVK1020-19. This is a smoked color. Please note the linked product review and installation videos below. If you do not have a Fan-Tastic Vent Ultra Breeze Trailer Roof…

view full answer...

Answer 4

Hey Scott, thanks for reaching out! The Replacement Flat Lid #DMC66FR is designed to replace the vent cover on a Dometic Fan-Tastic Vent 1250. So, while I'm not entirely sure what plastic post you're talking about, this will interact with the…

view full answer...

Answer 5

Since we don't have a confirmed fitting replacement for a 7300 I recommend taking a few measurements of your current cover's mounting hole locations and seeing it will match up to the Replacement Dome for Fan-Tastic Vent RV Roof Vents -…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

Hey Michael! The 2026 Kia Sportage Hybrid has the 12V battery integrated into the main battery so you won't be making a connection there. What you need to do is run the #C59236 hot lead to the 12V positive jump terminal under the hood. Everything…

view full answer...

Answer 11

Hey Aaron, since it's a Fan-Tastic roof vent the correct lid would be the part #FVK1020-19 that you referenced. They've only used the one roof vent lid design over the years.

view full answer...

Answer 12

Hello Richard, thanks for reaching out. The Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 does looks very similar to the vent lid in your picture, but we'll need to look more closely at how your current lid attaches. The…

view full answer...

Replacement Lid for Dometic FV1250 Roof Vent

Continue Researching