Does Curt Hitch 14301 Come with Install Hardware

Question

Question:

What is the hard wear kit number for this unit !!!!!

asked by: Mark E

0

Expert Reply:

The Curt hitch part # 14301 that you referenced does come with all of the hardware needed to install but if you lost yours and needed to replace it you'd want the part # RHK.

expert reply by: Jameson C

0

Answer 1

We have just what you need. If you type RHK in the search box on our website it will take you to the replacement hardware kit product page. You will then simply type the number of the hitch you need hardware for in the box that is labeled Hitch Item…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 5

Hey Kelly! The Curt 13146 fits 2016 - 2022 Honda Pilot. What you need for your 2026 Honda Pilot is the Curt #C22HR. This has a bolt-on installation and does not require any cutting or trimming of the bumper so you won't be modifying the vehicle.…

view full answer...

Answer 6

To install the Class IV Curt trailer hitch #14301 on your 2013 Chevy 1500 you will need to temporarily remove the spare tire for accessibility to the hitch mounting locations. After installation is complete and the spare tire is re-installed you will…

view full answer...

Answer 7

The best hitch I'd recommend for your 2011 Chevy Silverado is the Curt hitch part #14301 because it has great towing capacities at 10,000 lb trailer weight and because it has only the hitch tube that hangs below the rear bumper for a more…

view full answer...

Answer 8

The factory hitch that came with your GMC Sierra 1500 was at least a Class III and possibly a class IV depending on what trim level you have. Looking at the available products as well as your specific application and towing needs, I recommend…

view full answer...

Answer 9

Hey Lexie, the closest thing we have is the #BA65FR. This fits cutouts that are 5-1/4" wide x 4-1/2" tall. The little bit of extra height on your cutout won't be a problem since the face is 5-1/2" tall and would cover the opening.…

view full answer...

Answer 10

The mounting holes are slightly different between Curt trailer hitch #C14006 and #14301. I have included a side by side picture that shows this. Otherwise they have the same capacities. I have linked instructions for both hitch for you. If you plan…

view full answer...

Answer 11

Curt trailer hitch #13322 has the receiver right below the bumper. Take a look at the video I have linked showing a typical installation for you. You can see that once installed the hitch receiver will be directly below the rear bumper. This is a 2…

view full answer...

Answer 12

Hey Mark, thanks for reaching out, and good question. That “16/18 gauge” wording throws a lot of people off. The TowSmart 16 to 18 Gauge, 4 Conductor Wire #TS57QR isn’t all one size. It’s a 4-conductor cable with mixed gauges inside, two wires are 16…

view full answer...

Does Curt Hitch 14301 Come with Install Hardware

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching