Brake Controller Adapter Harness For 2022 Ram 1500 For Curt Discovery Brake Controller

Question

Question:

Curt Discovery Brake Controller. Do you have a connection cable for a 2022 Dodge Ram 1500?

asked by: Nick

0

Expert Reply:

There is; I checked with Curt and verified for you the correct brake controller adapter harness for your 2022 Ram 1500 and the Curt Discovery Trailer Brake Controller # C84VV is the following:

- Curt Custom Wiring Adapter for Trailer Brake Controllers # C51458

expert reply by: Kyle S

0

Answer 1

Thank you for the photo of your 2010 Ram 1500's under-dash wiring. The gray plug shown does appear to be the correct one for connection to the mating gray plug on the Curt wiring harness #C51438. This Curt connector is shown in the other photo so…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Thanks for reaching out Larry, Yea I did a double take when i seen 5500 lol If your 2019 Ram 5500 has the factory trailer tow package, the #RED87CR is indeed the correct fit and the mating connector should be present somewhere behind the dash. The…

view full answer...

Brake Controller Adapter Harness For 2022 Ram 1500 For Curt Discovery Brake Controller

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching