Solution for Carefree Colorado Travel-R Awning that Needs Replacement Jacketed 14 Gauge Wire

Question

Question:

I have a CareFree Colorado Travel-r awning. The motor cable is bad. It is 14 gauge 2 wire enclosed in a round jacket. Do you carry such a product? Thanks

asked by: Michael O

0

Expert Reply:

We have a pretty close option with the Jacketed 12 gauge wire part # 12-2-1 which we offer by the foot. This would work great to replace a double bonded 14 gauge wire setup. The slightly thicker core of the 12 gauge wire compared to 14 would not cause any issues. It's typically only ever going to be an issue if you were to go to slightly thinner gauge wire and not thicker like what I mentioned.

expert reply by: Jameson C

0

Answer 1

You should use 10 gauge wire for electric brakes which is pretty much the standard size for electric braking applications because it can handle the amperage better over the long distance from a brake controller to the electric brakes. For a nice…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 9

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 10

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 11

Hi Hayden; that bolt pattern is really uncommon but I believe it can be found on some really old Airstream trailers. There are no modern replacements that will match. The best option is to replace the hub with one that has a common bolt pattern like…

view full answer...

Answer 12

Hey Patrick, those dimensions don't appear to be anywhere from what I can find. While I can't give you that info, I can say that as long as the bearings fit, and you have a #11 or #12 spindle, then the Dexter Trailer Hub and Drum Assembly…

view full answer...

Solution for Carefree Colorado Travel-R Awning that Needs Replacement Jacketed 14 Gauge Wire

Product Page this Question was Asked From

Continue Researching