How to Program the Replacement Remote for Pace Edwards Bedlocker Retractable Hard Tonneau Cover

Updated 08/11/2022 | Published 08/10/2022

Question:

How do you program new remote

asked by: DAVID B

Expert Reply:

I have included the process for programming the Replacement Remote for Pace Edwards Bedlocker Retractable Hard Tonneau Cover # PE33QJ for you below.

1. Disconnect the power to the Bedlocker unit. (This can either be done at the battery or at the canister where the wires come out)

2. Reconnect the power and immediately push the open button on both remote key fobs.

3. Wait 15 seconds after pushing the buttons and try to operate the unit. (It should operate normally at this time)
The Electornics box goes into program mode for 2-3 seconds once power is reconnected. If power is lost to your
truck and the buttons are not programmed within 3 seconds of power being restored everything should stay as it
was. If you find this not to be the case please try reprogramming it as above.

expert reply by: Scott S