Recommended Rear Frame Center Mounted Tail Lights for Harbor Freight Trailer
Updated 08/10/2022 | Published 08/08/2022 >
Question:
Hi, I have a Harbor Freight trailer and now have broken the side mount tail/brake lights twice. I would like some rectangle or oblong surface mount lights to install on the rear rail but its only 3 inches tall. Anything you can recommend that would fit on that rail without hanging over? Thanks,
asked by: Jay
Expert Reply:
The ThinLine LED Tail Light part # STL76RB could be mounted horizontally on either side of the frame to provide stop, turn, and taillight signals for the trailer. They measure 13-1/4" long x 2-1/8" tall x 1-7/16" deep.
Product Page this Question was Asked From
ThinLine LED Tail Light for Trailers over 80" Wide - Stop, Turn, Tail - 11 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 13L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Can A Propane Regulator Be Replaced With Another That Has A Different BTU Rating
- Article: Trailer Wiring Diagrams
- Q&A: Thermostat Needed to Install Dometic FreshJet 3 AC Unit
- Q&A: Replacement Disc Brake Rotors and Hubs for a 2015 Road King Boat Trailer
- Q&A: Can Redarc Tow-Pro Link Replace Curt Echo on 2024 Jeep Wrangler Sahara With Factory 7-Way
- Q&A: What Gauge Wire does 4-Way Trailer Wiring Use
- Q&A: Can Fuse Tap be Used to Acquire Brake Signal for Brake Controller Install of 2017 Toyota Highlander
- Q&A: What Size Hole Needs To Be Drilled For a 2" Round Recessed Trailer Marker Light?
- Article: Double-Eye Trailer Suspension System Review
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy

