Where Do The Wires For The Replacement Control Module For Lippert Electric Coach Step Run To?
Updated 08/10/2022 | Published 08/08/2022
Products Featured in This Question
Question:
My old motor has 2 more wires going to the module.what do I do with them
asked by: Ray
Expert Reply:
Your control module # LC301702 should have a 2-pin connector coming from the harness that will connect to your Replacement Motor for Lippert Electric Coach Step # LC301695.
The 4-pin wiring harness # LC301692 will plug into your control module as well, and splice into your RV's wiring.
The color code is as follows:
-White Wire - Will connect to a power switch,
-Yellow Wire - Will connect to a power source that is only hot when the ignition is ON,
-Red Wire - Will connect to your RV's battery,
&
-Brown Wire - Will connect to your door switch.
Product Page this Question was Asked From
Replacement Motor for Lippert Electric Coach Step
- Accessories and Parts
- RV Steps
- Motors
- Lippert
more information >
Continue Researching
- Q&A: Replacement RV Step Motor for Part Number 300-1406
- Q&A: What is a Replacement for my Dometic CDMW12B Microwave?
- Q&A: Replacement Refrigerator for a Dometic RM2551
- Q&A: Correct Replacement Motor for Lippert Coach Steps 128980
- Q&A: Correct Replacement Step Motor for 59734-20
- Q&A: Replacement Parts for Lippert Electric Coach Steps 26 lci 165046
- Q&A: Demco Air Force One Braking System For Factory Prepped Tiffin RV
- Article: Most Popular Wheel Bearings
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Troubleshoot Your RV Air Conditioner