Distance to Set Hangers of Slipper Spring Hanger Kit with Slipper Spring e67SR
Published 07/29/2022 >
Products Featured in This Question
Question:
I purchased the HAP-105-00 single axle hanger kit along with the 5 leaf slipper spring model sp- 160275 and I need to know at what distance I should weld the hangers center to center one to the other to accommodate for the slipper spring. Thank you!
asked by: Alex M
0
Expert Reply:
With the Slipper Spring Single Axle Hanger kit part # HAP-105-00 and the Slipper Springs part # e67SR you'd want to set the hangers at a distance of 24-1/4 inches apart.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Single-Axle Trailer Hanger Kit for 2" Slipper Springs - 5" Front, 6-3/8" Rear
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Single Axle
- Dexter
more information >
Continue Researching
- Q&A: Recommended Equalizer Kit for 2 Inch Slipper Springs on Dual 9,000 lb Axle Trailer
- Q&A: Replacement RV Stove for Suburban SRNA3LBSE
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Comparing TruRyde 10-36 Grease and Dexter 10-63 Oil Seal
- Q&A: Can Dexter Over Under Axle Kit Be Used on Trailer with Slipper Springs
- Q&A: Dimensions of Hangers Included with Single-Axle Trailer Hanger Kit for 2" Slipper Springs APS6SE
- Q&A: Upgrading Tire Size and Suspension on a Homemade Hovercraft Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: How Long will the Axles Last on my Boat Trailer?
- Article: How to Measure a Trailer Axle
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: What Is A Leaf Spring? (Everything You Need to Know About Trailer Leaf Suspension)

