Distance Needed Between Hitch Ball and Sway Control Ball With Weld-On Tab
Updated 07/29/2022 | Published 07/28/2022
Products Featured in This Question
Question:
Is ok if the measurement between the two balls is 5 3/4” please help. Thank you
asked by: Louis J
1
Helpful Expert Reply:
Yes, the Weld-On Sway Control Tab # C45822 will be okay with a 5-3/4" spread between the hitch ball and the Sway Control Ball # C36BR. The Reese Sway-Control Bracket # RP26003 has a 5-1/2" distance between the center of the bolt holes. The 5-1/2" is the narrowest measurement you want for most applications.
expert reply by:
Bud M
1
Product Page this Question was Asked From
Continue Researching
- Q&A: Can Weigh Safe Hitch w/ Scale Be Used With Sway Control
- Q&A: Installation of Curt Front Mount Trailer Hitch Receiver # 31038 on 2003 Ford F-150 4 x 4
- Q&A: Looking for 2-1/2 inch Hitch Shank that Can Do 10 inches of Drop
- Q&A: What Is The Span Or Usable Length Of RV Designer Hitch Pin - 1/2" # RD83GR
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: Correct Lift Kit for Jayco Jay Feather Trailer
- Q&A: Purpose of Pink Wire in Harness for AirLift AL74000 Wireless ONE Air Bag Compressor System
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: Must-Have Flat Towing Components
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide
- Article: Trailer Wiring Diagrams
- Article: Is It Illegal to Leave My Hitch on My Truck?