Is there a Mounting Bracket for Trailer Back Up Light # BU33CB
Updated 11/01/2013 | Published 10/31/2013
Question:
Im adding backup lights to an older trailer. Using your BU-33CB lamps A33GB Grommets A45CB Connector Wires How do I mount the grommet to the trailer? Do I need to cut pocket in the back of the trailer for the grommet or can I buy some sort of box to house the grommet/lamp assembly?
asked by: Charlie
Helpful Expert Reply:
There is no bracket for external mounting of grommet # A33GB so you will have to cut a hole where you want the grommet and light to go. Use the grommet as a template to cut the hole. Start small because you can always work your way up to a larger hole if needed.
Product Page this Question was Asked From
Grommet for ST33 Series Tall Rectangle Flush Mount Trailer Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 6-1/4 Inch Long
- Rectangle
- Optronics
more information >
Continue Researching
- Q&A: Replacement Tail Light for a Thule Terrapin or Thule Transporter Hitch Mounted Cargo Box
- Q&A: Does Draw Tite Hitch DT75GR Fit 2025 Mercedes GLE 450
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Q&A: Replacement LED Light Assembly for Thule Transporter Cargo Carrier
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Replacement LED and Incandescent Lights for the Thule Transporter
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: What Does The E.R Error Code On My Tekonsha Primus IQ Brake Controller Mean?
- Q&A: Brake Controller and Wiring Harness for 2024 E-350 Motorhome
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams