Recommended Trailer Wiring Harness For A 1997 Chevrolet Blazer
Updated 07/12/2022 | Published 07/10/2022
Question:
No plug in play trl pig tails for 1997 s10 blazer? one recommended wont work
asked by: David P
0
Expert Reply:
Though we do not have any plug and play options available for your 1997 Chevrolet Blazer we do have The 4-Pole Hardwire Kit with Circuit Tester # 18252.
This harness will hardwire into your existing Chevrolet Blazer wiring, the turn and brake signals will be sent along the same wire. The ground wire will run the full length of the vehicle.
I attached an installation video link below.
expert reply by:
Noah E
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will The Hopkins Wiring Harness HM11141215 Fit My 1993 Chevy S-10 Blazer?
- Q&A: Recommended Hitch, Wiring, and Brake Controller for a 2025 Kia Carnival
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How To Install A Brake Controller On 2019 Chevy Equinox With Factory Package
- Q&A: Trailer Hitch Recommendation for a 1992 Chevy S-10 with Roll Pan Bumper
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Q&A: Curt Trailer Hitch Receiver # C14082 Tube Height From Mounting Flange For 1973 Ford F-100
- Q&A: Bolt Hole Spacing of Curt Class IV Hitch Receiver 14082
- Article: Troubleshooting 4 and 5-Way Wiring Installations