Which Relays and Fuses Are Required for Installation of Curt 56073 on 2007 Ford Freestar
Updated 07/12/2022 | Published 07/08/2022
Question:
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector Item # 56073 Which relays and fuses do I to make this work. Thanks in advance
asked by: Charles M
0
Expert Reply:
Installation of the Curt # 56073 on your 2007 Ford Freestar requires three relays and two 20 amp mini fuses. Carefully remove the fuse panel cover and insert the relays into 29, 30, and 31. Insert the fuses into positions 46 and 52. See the diagram from the instructions below.
expert reply by:
Robin H
0
Fuse And Relay Locations For Curt 56073 Installation.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- Factory Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Best Flat Tow Setup for 2026 Ford Maverick Hybrid
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Hopkins vs. Curt Flat Tow Wiring Harness For 2024 Jeep Wrangler
- Article: Trailer Tire Sizing
- Q&A: Recommended 30 Amp Active Controls ActiveStart Plug-In Soft Start for RVs
- Q&A: Recommended Wheel/Tires For 1995 Jayco Pop Up Camper
- Q&A: Which Trailer Hitch for 2019 Mercedes-Benz Sprinter 2500 Sits Higher Off Ground
- Q&A: Towing a Pop-Up Camper with 2014 Toyota Sienna