Installing LED Light Bulb Load Resistor Kit
Updated 10/02/2013 | Published 09/30/2013
Question:
i have an 09 chevy malibu and put some leds and i need to put the resistor kits but i dont know which wires to splice. which wires do i splice the resistor kits to.
asked by: Nayem
0
Expert Reply:
Each bulb should have a power wire and a ground wire. As you can see in the diagram I provided, one lead of the resistor is tapped into the power wire, and the other lead of the resistor can either ground to the vehicle or tap into the ground wire from the lamp.
expert reply by:
Mike L
0
click to enlarge
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Continue Researching
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Troubleshooting Hyper Flashing Trailer Lights on Mercedes-Benz Sprinter Van
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Q&A: Which Folding Handrail Is the Strongest? A Stainless Steel or Aluminum One?
- Q&A: How to Install LED Light Bulb Load Resistor for Use with Trailer with LED Lighting
- Q&A: Trouble Finding Brake Light Wire on a 2025 Ford F-150
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class