Can Center Section of Electric Waste Valve E40B-8 Replace Manual Setup
Published 05/23/2022 >
Question:
Do I need to cut the existing hub off and replace both in and out hubs? Or can I remove the 4 bolts, slide out manual valve and slide in the electric valve??? To try and cut off existing flanges and glue on new to my 3inch pipes would be a major replumbing job which is not worth the upgrade.
asked by: Bruce W
Expert Reply:
To make your life easier you could just remove the center section of your current waste valve and then install just the center section of the part # E40B-8 so that you can convert to an electric setup without having to deal with a much more involved install since the pipes are plastic welded and can't come apart without cutting.
Product Page this Question was Asked From
Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Hub
- RV Waste Valve
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Electric
- 3 Inch Hub
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Recommended Soft Start for a Furrion AC Unit
- Q&A: What Is The Shoe In A Schwintek Slide Out System And What Does It Do
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: Can Valterra EZ Valve Electric Waste Valve Be Installed Sideways Under 5th Wheel Trailer
- Q&A: Can Furrion Vision S+ Monitor Be Powered By USB
- Q&A: Best Complete Replacement For Kwikee 41 Series Double Step 904109000
- Q&A: Replacement Microwave for a High Pointe EM925AWW-B
- Article: Converting Your RV Water Heater to Tankless
- Article: What Does it Mean When an RV is Solar Ready?
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Can You Flat Tow a Ford Escape?
- Article: Ram Trailer Tow Prep Package
- Article: Dealer Spotlight - Hamilton Trailer Repair
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)

