Correct Replacement CH545 Key for Battery Door on Trailer

Question

Question:

Do you have replacement keys. None came w/trailer?

asked by: Linda D

0

Expert Reply:

Yes, we do have the correct replacement key for your battery door cover, it's the Replacement Key (545) for Steel Flush Door Latches part # CHK545.

expert reply by: Conner L

0

Answer 1

I wish I could say they couldn't but if someone ordered a replacement key like part #CHK545 and it was the correct key for your boxes they would be able to access them. Now that's pretty unlikely that someone would have the opportunity to do…

view full answer...

Answer 2

The Redline Replacement Key #CHK545 should be the correct key for the lock cylinder that is on your existing T-handle. This key is designed for T-handle locking door latches like what you have and the number matches up to the CH545 number you found…

view full answer...

Answer 3

So, most small locks with round cylinders have numbers on them somewhere- usually they're on the face of the lock, but they can also be found on the backs or imprinted on the internal lock cylinder themselves. If they have these numbers,…

view full answer...

Answer 4

We carry the replacement key you're looking for as part #CHK545.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Correct Replacement CH545 Key for Battery Door on Trailer

Product Page this Question was Asked From

Continue Researching