Triple LED Trailer Tail Light Has One Red LED Not Working Correctly
Updated 05/02/2022 | Published 04/25/2022
Question:
Purchased and installed last October 2021, passenger side brake, turn signal and back up working, turn on lights one red led not working. Why?
asked by: Willie L
Helpful Expert Reply:
I am sorry to hear that your Triple LED Trailer Tail Light # CE44VR is no longer working correctly. Typically if these lights do not work, there is either a wiring or ground issue. It could also be that particular LED has failed. I would check your wiring and grounds, if everything is in working order and getting the appropriate power then it is likely that an LED has failed and you would need to get a new # CE44VR to repair it.
Product Page this Question was Asked From
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
- Trailer Lights
- Tail Lights
- Backup
- Stop
- Tail
- Turn
- Rectangle
- Non-Submersible Lights
- LED Light
- 14L x 6-7/8W Inch
- Red
- White
- Command Electronics
more information >
Continue Researching
- Q&A: Possible Light Replacement For Monarch 5129 On 1977 Great Divide Trailer
- Q&A: Replacement LED Light for the Command 003-30
- Q&A: Replacement Taillight For 2018 Thor Chateau 31W Motorhome
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Tail Lights for a 2017 Thor Quantum 31WS Class C Motorhome
- Article: Trailer Wiring Diagrams
- Q&A: Trying To Find Replacement Part For Inverter
- Q&A: Wiring Installation on Command Electronics Triple LED Trailer Tail Light
- Q&A: How To Find Correct Replacement Taillight for Winnebago Minnie Winnie
- Article: Best Bike Racks for Electric Bikes
- Article: Rooftop Cargo Carriers
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Measure Your Trailer Wheel Bolt Pattern