Shock Absorbers in Convert-A-Ball Cushioned Ball Mounts
Updated 09/24/2009 | Published 09/23/2009
Question:
How many shock absorbers are in AMSC4?
asked by: Cary G
0
Expert Reply:
The Convert-A-Ball Cushioned Ball Mount, # AMSC4, has two shock absorbers, one in front of the pin hole and one behind the pin hole. This is true for all Convert-A-Ball cushioned ball mounts. Check out the diagram I attached.
expert reply by:
Robert G
0
click to enlarge
Product Page this Question was Asked From
Convert-A-Ball Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 10,000 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- Steel Shank
- Drop - 4 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- Shock Absorbing
- Convert-A-Ball
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What Should Torque Setting be for TowSmart Hitch TS89ZR Nissan Murano
- Q&A: USA Made 2 inch Trailer Hitch Balls
- Q&A: Does etrailer High-Low Fixed Adapter Have Tongue Weight Rating
- Article: What Do I Need To Tow A Trailer?
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Determine Tire/Wheel Diameter
- Article: Rust Prevention
- Article: Trailer Tire Sizing
- Q&A: Parts Needed to Install Redarc Brake Controller on a 2023 Ford Bronco
- Q&A: How to Tell if 12v Circuit on 7-Way is Active on 2019 Volkswagen Atlas
- Q&A: Are etrailer Horizontal E Tracks Electro-Galvanized or Hot-Dip Galvanized?
- Q&A: Does Curt RockerBall C94CR Have More Cushion Than Curt RockerBall C40047