How Do I Wire LED Flood Lights on My Camper to Use When Backing Up?
Updated 04/14/2022 | Published 04/13/2022 >
Products Featured in This Question
Question:
So i can run off of the running lights? Why wouldn't i be able to switch it? I would only be drawing power from the running light circuit, the switch would be after the running light. Remeber this is on a slide in camper/topper, not the actual truck lights.
asked by: William
Expert Reply:
Another option than running the LED light to the battery is by running the wiring to the running lights. Although, this can be just as difficult as running it to the battery.
The best route is to run the wiring to the reverse lights. However, if you go this route, you must go without a switch option. The only way to use a switch is to go directly to the battery.
If you need extra wiring for the application, I recommend using the 18-Gauge 2-Wire Bonded Parallel Conductor Wire - per Foot # SWC97FR along with some Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 10 # DW05743-10.
Product Page this Question was Asked From
Deka Heat Shrink Butt Connector - 22-18 Gauge - Nylon Insulation - Red - Qty 10
- Wiring
- Wire Connectors
- Butt Connectors
- 18 Gauge
- 20 Gauge
- 22 Gauge
- Deka
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Flat Tow Components for 2023 Ford F150
- Article: Trailer Wiring Diagrams
- Q&A: Is There A 1.5" Hitch To 2" Hitch Adapter?
- Q&A: Replacement Fenders for 2003 Champion 203 Boat Trailer
- Q&A: Recommended Disc Brake Pads for a Dexter 89-3 Caliper
- Q&A: Cross Referencing a Dexter Hub with 70-7 Stamped On It
- Q&A: How to Replace a 4-Way Trailer Connector with 8 Wires
- Q&A: Availability Of 5 on 4-1/2" Hubs For A 3/4" Spindle
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Best Hitch Cargo Carriers
- Article: Dealer Spotlight - Toucan's Auto Repair
- Article: Routing the Power Wire for a Trailer Wiring Harness



William
1/1/0001
So i can run off of the running lights? Why wouldn't i be able to switch it? I would only be drawing power from the running light circuit, the switch would be after the running light. Remeber this is on a slide in camper/topper, not the actual truck lights.