Height of Galvanized Steel Uprights of CE Smith CE27740 Boat Trailer Guide-Ons  

No. In most cases getting paint to stick to the galvanized steel on the CE Smith Post-Style Guide-Ons #CE27740 is not going to be possible because of the layer of zinc that's left after galvanization. I don't recommend painting them as…

I think that question is dependent on how much flexing you're talking about. The CE Smith Post-Style Guide-Ons #CE27626 are made out of PVC pipe so there is some flex that can happen, but a heavy boat could easily snap the PVC if you're…

The dimension of the bracket that comes with the #CE27626 that you sent in a picture of is 3 inches.

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

The CE Smith Post-Style Guide-Ons #CE27740 are lighted poles to help guide your boat on to the trailer. CE Smith does have Light Mounting Brackets for Post-Style Boat Trailer Guide-Ons #CE27650A were you could mount a set of stop lights like #2423056…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…