Are Fuses Added to a 2013 Honda Accord to Install Curt Trailer Wiring Harness # C56011
Updated 09/03/2013 | Published 08/30/2013
Products Featured in This Question
Question:
Installed 56011 quickly and easily. Car lights seem to work and signals are going to the pig tail. Do I need to add a 10amp fuse to my car fuse box? I will check lights again once its dark outside.
asked by: Carl M
Helpful Expert Reply:
No, there is no fuse that you will need to add for Curt wiring harness # C56011 to work on your 2013 Honda Accord. The trailer lights are powered by the vehicle tail light wiring.
This wiring harness was designed to work with sedan models that do NOT have LED tail lights. If your vehicle is a sedan and it does have LED tail lights you would use # C56173.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Curt Hitch that Fits 2010 Mazda 3 Sedan
- Q&A: Trailer Hitch for 2010 Mazda 3 S
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Why Choose a Powered Taillight Converter Over a Non-Powered Model
- Q&A: What is the Difference Between the Curt C56190 and C59236 for 2011 Audi SQ5
- Q&A: Replacement Mounting Hardware For Curt Receiver # C13315 On 2022 Mazda CX-5
- Q&A: Can 2009 Honda Civic Tow 1,000 lb Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting 4 and 5-Way Wiring Installations