Wiring Harness and Functions for Optronics GLOLight LED Stop/Turn/Tail Light
Updated 08/27/2013 | Published 08/24/2013
Products Featured in This Question
Question:
will this plug into 1998 chev g3500 standard 3 prong pluds
asked by: Gordon B
Expert Reply:
It all likelihood the connector on your 1998 Chevy truck will not match up to the input on the Optronics GLOLight, # STL101RCB. You would need a harness made for the light, # A47PB and then splice the wires from it to the trucks wires. The truck will have to have combined brake lights and turn signals on the same wire for this to wire up correctly.
On the wiring harness, white is ground, red is turn signal and brake lights, and black is running lights.
Product Page this Question was Asked From
GloLight Halo LED Trailer Light - Brake, Turn, Tail - Submersible - Round - Red and White
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Q&A: Landing Gear Switch Installation and Wiring Diagram
- Q&A: Recommended Cover for B&W Companion Slider 5th Wheel Hitch
- Q&A: How to Verify if Timken 3,500 lb Axle Bearing Kit is Correct for Tracker Boat Trailer
- Q&A: Lumen Output of the Thinline LED Trailer Tail Light # STL59RCB
- Q&A: Replacement 2 Inch Round Amber Side Marker Light with Silver Bezel
- Q&A: Will The Tekonsha 119250KIT Work On A 2021 Audi Q5 Hybrid