Replacement Side Rails For A Retrax Tonneau Cover On A 2020 Ram 2500 Long Bed

Question

Question:

Made a mistake with the previous question because it is a 8 foot bed and it came out wrong on the email that just set up

asked by: Chuck C

0

Expert Reply:

For your 2020 Ram 2500 long bed, if you have the RetraxPRO XR Hard Tonneau Cover # RTT-80233 or the RetraxPRO MX Hard Tonneau Cover # RT80233, then you can use the Replacement Side Rails for Retrax XR Series Hard Tonneau Cover # RTX45FR for a replacement.

expert reply by: Bryce D

0

Answer 1

The channels of the RetraxONE XR part #RTT-82383 are a standard size which means standard roof rack t-bolts like the #853-5715 would work.

view full answer...

Answer 2

The Replacement Track Adapter Installation Hardware #Y69KR are the wide M8x35 t-bolts. The wide fits the Retrax XR covers. The Tonneau Cover Adapter Kit for Yakima OverHaul HD and OutPost HD Truck Bed Ladder Racks #Y01155 which includes the pads and…

view full answer...

Answer 3

The correct replacement rails to convert your RetraxPro MX like the #RTX85ZR or #RTX72FR into the XR will depend on your bed length. For your 2021 Ford F-150 you will need one of the following: -5-1/2' Bed: #RTT-82381 -6-1/2'Bed: #RTX49FR

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Side Rails For A Retrax Tonneau Cover On A 2020 Ram 2500 Long Bed

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching