Replacement Waste Valve for RV Black Water Tank
Updated 02/28/2022 | Published 02/25/2022
Question:
Not sure what happened over the winter, but I went out to the trailer and discovered the valve laying on the ground. All the bayonet gripsfoot but one were broken off. Since that part is ring that rotates around the fixture, can it be replaced and if so, do you sell the bayonet ring?
asked by: Daryl L
0
Expert Reply:
I suggest replacing with the Valterra Waste Valve for RV Black Water Tank - Twist On - 3" Bayonet Hooks to 3" Lug
Item # T58. We offer this as a complete replacement assembly.
expert reply by:
Michael R
0
Product Page this Question was Asked From
Valterra Waste Valve for RV Black Water Tank - Twist On - 3" Bayonet Hooks to 3" Lug
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Manual
- 3 Inch Bayonet
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: How to Gain Additional Clearance on Brinkley Model G 3970 With Gen-Y Gooseneck Pin Box
- Article: Thank you!
- Q&A: What are Bag Dimensions of Andersen Camper Leveler part # AN68VR
- Q&A: Internal and External Dimensions of MORryde Sliding Tray for RV Cargo Compartment # MR77FR
- Q&A: Availability of 7-Way Trailer Connector With 8 Gauge Wire for Power and Ground
- Q&A: Can Extension Rods in Valterra Waste Valve Extension Rod Kit be Attached to Each Other
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Recommended Convection Microwave for a 20-1/2 Inch Wide Cutout
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub