Do You Have to Remove the Hub When Installing the Wheel Masters 2-Hose Inflation Kit
Updated 02/23/2022 | Published 02/22/2022
Question:
Hello, I have a 2020 Thor Aria 3901 with 22.5inch wheels. Do I need to remove the outer tire / hub in order to install the mounting bracket ? Thank you
asked by: Rich B
Helpful Expert Reply:
When installing the Wheel Masters 2-Hose Inflation Kit # WM8005 (Hub Mount), you are going to need to drill 2 holes into each hub and attach the brackets with rivets. Technically you could probably do this with the hub left on, but you will probably find it easier to remove the hub. I have attached a video that shows this being installed. It is not on a 2020 Thor Aria like yours, but you may still find it helpful.
Product Page this Question was Asked From
Wheel Masters 2-Hose Inflation Kit - 22-1/2" Dually - Hub Mount
- Tire Inflator
- Inflation Kit
- 22 Inch Dual Tires
- Dually Vehicles
- Wheel Masters
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Floor Flange Seal for Dometic 300 Series Toilet
- Q&A: Replacement Gas Strut For a Stabilus 654150 0550N 275/12 A 15
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Need Wiring Instructions for Wall Remote Switch # VC0533-03-A on Ventadome Roof Vent with 12V Fan
- Q&A: Tip for Fitting Blue Ox Patriot Braking System in 2014 Jeep Wrangler
- Q&A: Seat Stiffener to Secure a Supplemental Braking System in Vehicles with Soft Seats
- Q&A: Starter Solenoid for Generac Generator
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: RV Propane 101: How Does My RV's Propane System Work?