Instructions for Installing GCH Automotive Third Brake Lamp Camera on Ford Super Duty Truck
Updated 03/09/2026 | Published 02/19/2022 >
Question:
Product 3460007 Do you have a link to the mfg install instructions? Did not come with the product
asked by: Allen
Expert Reply:
Here's a screenshot of the installation instructions.
In summary, you'll remove the existing 3rd brake lamp, and install the new one after feeding the wiring harness into the opening on the rear of the cab above the rear window. Make sure the foam gasket is in place, adding a bead of silicone or butyl tape is recommended to ensure the seal between the lamp housing and the truck cab is watertight.
Feed the harness up to the front of the vehicle, routing the wiring under the threshold plates is typically the easiest route. The harness will plug inline at the rear of the factory monitor as shown in the diagram on the instructions sheet.
Product Page this Question was Asked From
Custom Third Brake Light Camera for Aftermarket Monitor - Night Vision
- Accessories and Parts
- Backup Camera
- Third Brake Light
- Third Brake Light Camera
- For Aftermarket Monitor
- GCH Automotive
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Truck Bed Camera
- Shop: Progressive Dynamics 9300 Series RV Converter Charger - 12V - 60A
- Search Results: third brake light camera
- Shop: Progressive Dynamics 9300 Series RV Converter Charger - 12V - 45A
- Q&A: Looking for Replacement Distribution Panel for IOTA IDP-30
- Shop: Custom Third Brake Light Camera for Aftermarket Monitor - Night Vision
- Shop: Progressive Dynamics 5000 Series AC/DC Distribution Panel - 30 Amp
- Q&A: What Is The U-Shaped Wire Used For On The Custom Third Brake Light Camera?
- Search Results: battery trays
- Search Results: ac/dc distribution panel
- Shop: Custom Third Brake Light Camera for Aftermarket Monitor - Night Vision
- Shop: Custom Third Brake Light Camera for 8" Factory Monitor - Night Vision
- Search Results: victron dc to dc
- Shop: Custom Third Brake Light Camera for 7" Factory Monitor - Night Vision
- Search Results: progressive dynamics rv power converter
- Q&A: Best Replacement For WFCO 45 AMP Model WF-9845 Converter
- Q&A: Can a Higher Amp RV Converter Be Used for Replacement
- Q&A: What is Difference Between 45 amp and 60 amp Progressive Dynamics Converter Chargers
- Search Results: front receiver hitch
- Video: Ultimate Overview of the Custom Third Brake Light Camera for Aftermarket Monitor
- Shop: Front Mount Hitch
- Q&A: 2009 Ford F-350 Super Duty Third Brake Light Camera Compatibility
- Shop: Fifth Wheel Hitch
- Shop: RV Jack Pads
- Video: Review of SnapPad RV Jack Pads - XTRA Square 6 Jack Pads Level Up Leveling Jacks - SN99FR
- Search Results: truck bed camera
- Q&A: Can GCH Third Brake Light Camera # 3460007 Connect to Kenwood Stereo DMX9706S
- Shop: Tool Box
- Shop: BOLT brand vehicle and hitch locks
- Shop: Side Window Vents




Patrick
3/9/2026
I have it install but it is showing backup lines and I don't need them. How do I turn them off and no it is not my monitor. I have that feature turned off and double checked using a second monitor.