How to Replace Bulbs in ST47RB Optronics Incandescent Trailer Stop/Turn/Taillight
Published 02/11/2022
Products Featured in This Question
Question:
How do I open it to replace the lamp?
asked by: Dale
1
Helpful Expert Reply:
The housing of the Optronics # ST47RB lamp is held together by two screws that are accessed from the rear of the lamp housing. Once the screws are removed, the lens can be removed from the housing and the 1157 bulb, part # DI79VR can be replaced.
An LED version is available as part # M824R. The LED lamp uses less power, will be much brighter and will last up to 50 times longer than a comparable incandescent lamp.
expert reply by:
Mike L
1
How to Disassemble Optronics ST47RB Trailer Taillight
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Round - Grey Flange - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 5-1/2 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Article: How to Measure a Trailer Axle
- Q&A: How to Select the Proper Length Safety Chains for a Trailer
- Q&A: What Hitch will Not get in the Way of My 2025 Subaru Forester Hands Free Lift Gate?
- Q&A: Is LED Trailer Tail Light # 328-003-6019R Sold Individually or In Pairs
- Q&A: Adapter Plug For Optronics ONE LED Tail Light
- Article: Trailer Lighting Requirements
- Q&A: Replacement For Landing Gear Motor MQ887
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Running Hot-Line LED Trailer Light Bar as Brake Light Only
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: RV Pre-Departure Checklist