1998 Ford E-350 Cargo Van Floor Mat Recommendation

Question

Question:

I have a 1998 E350 extended cargo van and was interested in one of your floor matts. The approximate length of the cargo area is between 130 and 136 in depending on how you measure it We have a partition installed between the cargo area and the driver. Can you send me a link to the one that would fit our van and is it something that we would be able to cut with a razor knife if we needed to contour it around some work bins that are currently installed? I can provide you with the last five digits of our VIN if that will help or any photos you might want. Thanks,

asked by: Douglas H

0

Expert Reply:

We do have floor mat options for your 1998 Ford E-350. I recommend going with the VanTred because it gives you better protection with the thermoplastic material as opposed to the standard carpet protection:

Standard Wheelbase - # VTRF92
Extended Wheelbase - # VTRF92X

You can contact your local Ford dealer with your VIN and they can let you know which wheelbase you have. This floor mat can be cut through to accommodate for your work bins.

expert reply by: Jon G

0

Answer 1

We do have a thermoplastic floor mat for your 2011 Ford E-350 extended van. It's the VanTred #VTRF92X. This mat is a 1/2 thick and extends from behind the seats to the plastic shroud at the cargo doors. It's waterproof, easy to clean, and…

view full answer...

Answer 2

The VanRug Custom Floor Mat for Cargo Vans - Charcoal Gray - Carpet #VRF92X is a confirmed fit for the extended wheelbase van and is 136-1/2 inches long from the back of the front seats to the back of the van and is 3/4 inches thick. If you want the…

view full answer...

Answer 3

I have a bed mat for you but unfortunately the DeeZee Custom-Fit Truck Bed Mat part #DZ86887 you mentioned is not designed to fit your 2004 Ford E-150 extended wheelbase. Instead you can use VanTred Custom Floor Mat for Cargo Vans - Black -…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Since your 2011 Ford E-350 does not have the factory towing package you will need to start with adding a 4-way connector. I recommend the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56020 which will plug into your…

view full answer...

Answer 8

Actually all you need to install a brake controller in your 2010 Ford E-350 Van is the correct install harness part #3034-P. Basically this plugs into the back of your brake controller and then plugs into the port under the dash of the van. If you…

view full answer...

Answer 9

I do have an option for you but there is not an upgrade kit for a Fan-Tastic Vent E-Z Breeze Model 600 Vent Fan. Therefore, you will need to replace this for which I recommend using the Fan-Tastic Vent Model 2250 Roof Vent Fan part #FV802250 as it…

view full answer...

Answer 10

For your 2006 Ford 350 extended wheelbase van we have the part #VTRF92X which is a confirmed fit. The part #VTMS06L that you referenced is for a different vehicle and would not work for you.

view full answer...

1998 Ford E-350 Cargo Van Floor Mat Recommendation

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching