Where Is The 4" Hole Drilled In The Bed To Install The B&W Turnover ball Gooseneck Hitch BWGNRK1110?
Published 01/29/2022 >
Question:
Center hole for a 97 short bed 4 wheel drive
asked by: DOUG H
0
Expert Reply:
The 4" hole for the B&W Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1110 is going to be centered between the fenders and 49" from the tailgate on your 1997 Ford F-350 short bed 4wd with the overload springs.
expert reply by:
Bud M
0
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Flip-Over Ball
- 7500 lbs TW
- 30000 lbs GTW
- Wheel Well Release
- Spring-Loaded Loop
- B and W
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Installing the B&W Turnoverball Underbed Gooseneck Hitch on a 1997 Ford F-350 with Duraliner
- Q&A: Wiring Brakes On Tandem Axle Trailer
- Q&A: How to Determine the Fit of a Gen-Y Fifth Wheel to Gooseneck Executive Adapter
- Q&A: Are Firestone Air Bags for 1996 F-250/F-350 Compatible With In Bed Hitch
- Q&A: How to Tell if 1997 Ford F350 Has Overload Springs
- Q&A: Recommended Transmission Cooler For 1995 Ford F250 With 7.3L Diesel Powerstroke Engine
- Q&A: Are There Air Bags for a 1997 Ford F-350 with In-Bed Hitch
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Fix a Bad Trailer Ground



