Will The Curt 13445 Hitch Fit A 2008 Toyota 4Runner With Aftermarket Dual Exhaust?
Updated 01/19/2022 | Published 01/18/2022
Question:
2008 4runner X-SP V6 RWD. Can this hitch fit with a dual Borla exhaust? Or is there a better option? Thanks
asked by: Scott
0
Expert Reply:
As the Curt Trailer Hitch # 13445 is designed to fit a 2008 Toyota 4Runner with stock exhaust, so I cannot say for sure if it will fit with a dual Borla exhaust system. However, this hitch will attach to the bottom of the frame and the cross-tube will measure the same as how inside the frame will. So if your exhaust system sits outside the frame of your 4Runner, there should not be any issue installing the hitch with it.
expert reply by:
Lazer S
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Trailer Hitch for 2007 Toyota 4Runner that Dpes Not Require Fascia Trimming
- Q&A: Is Loctite Required When Installing a Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does Installation of Curt Hitch Require Specific Bumper or Modification on 2007 Toyota 4Runner
- Q&A: Replacement Klauber Slide Out Motor A-300 K01336A300 for RV
- Q&A: Trailer Wiring Recommendation for 2007 Toyota 4Runner that Has Two Connectors
- Q&A: Mounting the Replacement Wiring Harness For Factory 7-Way On a 2008 Toyota 4Runner
- Q&A: Demco 2" A-Frame Couplers Dimensions Requirements
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Determining Trailer Tongue Weight
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)