Inside Dimensions of Bar Mount Assembly for Thule Hullavator Pro for Mounting on 2006 Nissan Xterra
Published 01/12/2022
Products Featured in This Question
Question:
good morning, I have an Xterra and need to mount a cross bar on my roof rack, that this part will fit over. I was thinking about buying unistrut 1 5/8inch x 7/8 and using U bolts to attach to my round bars. can you tell me the inside dimension? Im guessing 1.5inch to 2inch wide by 1inch deep. thx.
asked by: Camille S
Expert Reply:
The channel on the underside of the Replacement Bar Mount Assembly # 7521741001 is 1-1/2" wide and has a 1/2" depth. To mount the Thule Hullavator Pro Kayak Carrier # TH898 to your 2006 Nissan Xterra I recommend picking up the Inno roof rack system which the Hullavator Pro will mount directly to:
45" Inno Aero Crossbars - # INXB115-2
Inno Through Feet - # INXS150
The feet will mount directly to your OEM roof bars and give you your standard crossbars for mounting accessories.
Product Page this Question was Asked From
Replacement Bar Mount Assembly for Thule Hullavator Pro Kayak Carrier and Lift Assist - Qty 1
- Accessories and Parts
- Watersport Carriers
- Roof Mount Carrier Parts
- Bars
- Hullavator
- Thule
more information >
Continue Researching
- Q&A: How Does Thule Hullavator Attach to Crossbars with Rubber Strip in Channel
- Q&A: Hardware that Goes Through Thule Crossbar Mount Cover for Thule Hullavator
- Q&A: Roof Rack Recommendation for 2026 Nissan Frontier to Carry Thule Hullavators
- Q&A: Does the Thule Hullavator Have to Be Installed Using the T-Slots in Thule Wingbar Evo Crossbars
- Q&A: Replacement Bar Mount Assembly for Older Thule Hullavator 897
- Q&A: Recommended Roof Rack for a Hullavator on a 2019 Jeep Wrangler Hard Top
- Q&A: Recommended Roof Rack for a Hullavator on a 2022 Jeep Wrangler
- Article: Brake Controller Installation: Starting from Scratch
- Article: Determining Trailer Tongue Weight
- Article: Trailer Maintenance Schedule
- Article: How to Strap a Kayak to a Roof Rack in 4 Steps (With Pictures)