Do I Need to Ground LED Load Resistors on My Upgraded LED Turn Signals on a 1997 Jeep Wrangler?
Updated 12/30/2021 | Published 12/29/2021
Question:
i wanted to put led smoke turn signals and i read i needed to buy resistors i looked at them on your site but i am not sure if they have to be grouded or just the single wire hook up thanks
asked by: Chuck
0
Expert Reply:
Thanks for reaching out to us here at etrailer. It really depends on which LED lights and component you are referring to. Are you talking about your factory tail lights on your 1997 Jeep Wrangler with a 4-way wiring harness?
expert reply by:
Bob C
0
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Article: Trailer Wiring Diagrams
- Q&A: Solution for Rapid Signal Flashing on Utility Bed with LED Lights
- Q&A: Parts Needed to Add Third Brake Light to Trailer With LED Lights
- Q&A: Load Resistors to Fix Rapid Flashing LED Lights
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
Chuck
1/1/0001
i wanted to put led smoke turn signals and i read i needed to buy resistors i looked at them on your site but i am not sure if they have to be grouded or just the single wire hook up thanks