What are the Dimensions of the U-Shaped Support on the Ultra-Fab Slide-Out Supports
Question:
hi! how many inches wide is the u shape of the top of these jacks? i am trying to see if these will work for our lifetime trailer that converts with a tent top.
asked by: Rachel
1
Helpful Expert Reply:
I went out to the warehouse and took some measurements of the top of the Ultra-Fab Slide-Out Supports, # UF19-960002. The inside width is 4-3/4 inches. The outside width is 5 inches. The height is 1-3/8 inches and the front to back measurement is 2-1/2 inches.
I have included a picture showing some of these measurements for you.
click to enlarge
helpful expert reply by: Michael H
1
Product Page this Question was Asked From
Ultra-Fab Slide-Out Supports for Motor Homes - 21" to 37" - Qty 2
- Camper Jacks
- Stabilizer Jack
- Slide-Out Supports
- 1001 - 2000 lbs
- 37 Inch Lift
- 2 Jacks
- Ultra-Fab Products
more information >
Similar Expert Q&A Pages
- Do Slide Out Jacks Help on RVs with Slide Outs
- Slide Out Support For Travel Trailer
- Any Known Issues/Damage to Slide-Outs Due to Ultra Fab Slide Out Supports UF19-960002
- Recommended Products To Stabilize Grand Design Reflection Travel Trailer When Camping
- Slide-Out Supports for 2013 Palomino Solar Ultra Lite Travel Trailer Frame Beam
- Recommendation for 5th Wheel Trailer Slide-Out Stabilizers
- Fitment of Slide Out Stabilizers on a RV
- How To Support Slide-Out On 1998 Monaco Diplomat
- How to Determine Correct Slide-Out Support For Motorhome
- Hitch Installation Support Jack for Stability
- Recommended Stabilizers for RV Patios
- Stabilizer Jack Setup for Hithhiker 5th Wheel
- Operation and Sturdiness of Stromberg Carlson Camper Jack # JB-20 when Fully Extended
- Looking for Jacks to Stabilize a Slide Out on an Older Travel Trailer Camper