Custom Wiring Adapter for the Curt TriFlex Brake Controller on a 2017 Chevrolet Silverado 1500

Question

Question:

Need the correct connection cable for the Curt Triflex brake controller. Its being installed in a 2017 1500 Z71 Silverado. I cannot find the correct one on the site. Please let me know. Thanks

asked by: David H

1

Helpful Expert Reply:

The correct wiring adapter for the Curt TriFlex Trailer Brake Controller # C24VV for your 2017 Chevrolet Silverado 1500 is the Curt Custom Wiring Adapter # C51451. This will plug into the TriFlex and then into the port under the dash of your truck.

expert reply by: Scott S

1

Answer 1

Yes, the Curt brake controller install harness part #C51451 that you referenced will allow you to install a Curt brake controller in your 2015 Chevy Silverado 1500 like the Curt TriFlex part #C24VV.

view full answer...

Answer 2

The Curt TriFlex Trailer Brake Controller #C24VV does have a sleep mode that will not have any lights on when the controller is not being used. It sounds like you have a short somewhere in the brake wire that runs to the 7-way since your controller…

view full answer...

Answer 3

For your 2015 GMC Sierra 1500 and Curt TriFlex brake controller #C24VV you will need wiring harness #C51451 to plug the controller into your truck. I have linked instructions for both parts for you.

view full answer...

Answer 4

The Curt Spectrum Trailer Brake Controller #C51170 is a great choice for a brake controller in your 2018 Chevy Silverado 1500 because it is easy to use with the control knob you referenced and is a proportional controller so you will get smooth…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hello Michael, The Curt Custom Base Plate Kit - Removable Arms #C55KR is going to be a great fit for your 2018 GMC Sierra 1500, and your Blue Ox BX7335 Aventa II tow bars will connect perfectly to the Curt base plate. Are you new to flat towing, or…

view full answer...

Custom Wiring Adapter for the Curt TriFlex Brake Controller on a 2017 Chevrolet Silverado 1500

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching