Correct Bearing Buddy Bearing Protectors for 7K Axle with 14125A Outer Bearing

Question

Question:

Wanted to see What grease buddies would I need for that 7K axle. Old parts are 14125a 25580 010 036 00

asked by: Shawn S

0

Expert Reply:

The correct Bearing Buddy Bearing Protectors for a 7K trailer axle with 14125A outer bearing should be the part # BB2717 which is for a 2.717" hub bore.

expert reply by: Conner L

0

Answer 1

Hey Milos, it's actually pretty easy to overfill trailer hubs with grease using the EZ lube grease fittings which then blows out the grease seal. What we've found is that if you pack the hub with grease by hand that is the actual best…

view full answer...

Answer 2

Hey Milos, the better option is the Bearing Buddy part #BB87SR which is the 2717A which has a couple more features like the blue indicator ring that makes it a little easier to see when it's full compared to the #BB2717.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 6

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 7

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 8

Hey Al, I have a solution for you but we don't have anything that is a direct replacement for the Kodiak 204 caliper including the DeeMax you referenced. . Since Kodiak was bought out by Dexter it seems they discontinued the 204 caliper in favor…

view full answer...

Answer 9

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Correct Bearing Buddy Bearing Protectors for 7K Axle with 14125A Outer Bearing

Product Page this Question was Asked From

Continue Researching