Drill Bit Used For Wheel Masters 2-Hose Inflation Kit
Published 11/19/2021
Question:
Your video mentions a 1 inch drill bit. I doubt it is a 1 inch diameter bit. Do mean a bit that is the same diameter as the rivet tool and is 1 inch long?
asked by: Al
0
Expert Reply:
You are correct; the drill bit will actually be a 1/8" drill bit for the installation of the Wheel Masters 2-Hose Inflation Kit - 22-1/2" Dually - Hub Mount # WM8005.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Wheel Masters 2-Hose Inflation Kit - 22-1/2" Dually - Hub Mount
- Tire Inflator
- Inflation Kit
- 22 Inch Dual Tires
- Dually Vehicles
- Wheel Masters
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Floor Flange Seal for Dometic 300 Series Toilet
- Q&A: Replacement Gas Strut For a Stabilus 654150 0550N 275/12 A 15
- Q&A: Brake Controller Recommendation for a Truck with Air Brakes and a Trailer with Electric Brakes
- Q&A: Need Wiring Instructions for Wall Remote Switch # VC0533-03-A on Ventadome Roof Vent with 12V Fan
- Q&A: Tip for Fitting Blue Ox Patriot Braking System in 2014 Jeep Wrangler
- Q&A: Seat Stiffener to Secure a Supplemental Braking System in Vehicles with Soft Seats
- Q&A: Starter Solenoid for Generac Generator
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: RV Propane 101: How Does My RV's Propane System Work?