Which Frost Plug to Use For Installing Block Heater on 2011 Ford Escape 3.0
Published 10/28/2021
Question:
Hello I purchased your product the other day and I was curious where on a 2011 Ford Escape limited 3.0 the right frost plug is to replace with the heater and how to go about doing that
asked by: Daniel
Expert Reply:
The Kat's block heater part # KH11409 that you referenced does fit your 2011 Ford Escape with a 3.0 liter and the frost plug you are going to use is located in the right rear location which means as you are looking at the engine from the front of it it's the location around the back corner on your left/passenger side. You'll need to unthread the plug that's there currently and then thread this back in it's place.
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Threaded Immersion - 120V - 400 Watts - 3/4" NPT
- Vehicle Heaters
- Engine Block Heater
- Frost Plug Style
- 400 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Q&A: Where is the Port for the Block Heater # KH11815 on a 2018 Ford F-150 with a 3.5L V6 EcoBoost Engine
- Q&A: Where to Install Engine Block Heater On a 2011 Ford Flex With 3.5L Non-Ecoboost Engine
- Q&A: Engine Block Heater For a 2024 Ford F-150 With 3.5L EcoBoost V6 Engine
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Q&A: How to Attach Magnetic Emergency Light to Aluminum Body Truck
- Q&A: Recommended Engine Warmer for a 2016 Ford Focus with 2.0 Engine
- Q&A: Install Instructions for Kat's Block Heater KH11409
- Article: Performance Chips and Modules
- Article: Rooftop Cargo Carriers
- Article: Which Hitches are Made in the USA
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains