How Does the On/Off Push Button Install and Work
Updated 09/30/2021 | Published 09/26/2021
Question:
All I need to know before ordering product is a push button on and off two black wires coming from push button how to wires two a electric lamp do you cut just one of the two wires from the plug and attach the push button switch in between to inturup power to the lamp thanks
asked by: Joe M
Expert Reply:
The On/Off Push Button Switch for RV Lighting # DG52452VP doesn't have a specific wiring diagram, it would vary depending on your intended use. Basically the switch will install into the circuit you are needing to interrupt so that the current can flow through it when it is on and cuts off the current when it is off.
I can not say for sure without seeing/knowing your exact scenario but more than likely yes, you will splice this into the wiring between the plug and lamp.
Product Page this Question was Asked From
On/Off Push Button Switch for RV Lighting - 4" Wire Leads - Black
- RV Light Switch
- Push Button Switch
- Single Switch
- On/Off
- Cover Plate Not Included
- Black
- Diamond
more information >
Continue Researching
- Q&A: Why Does the RV Holding Tank Heater Have a Separate Ground Wire and Not a 3 Prong Plug?
- Q&A: Replacement Refrigerator for RV for Norcold 1095R
- Q&A: Replacement Front Jack For Lippert Ground Control 3.0 6-Point System
- Q&A: Amp Rating, Wire Gauge, and Dimensions of On/Off Push Button Switch for RV Lighting
- Q&A: Replacement 58 inch Arm for Solera Edge RV Awning
- Q&A: Replacement for Kwikee Control Module 909513
- Q&A: How To Wire In Three Thermat Heat RV Tank And Pipe Heater Pads
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller Installation: Starting from Scratch
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Ugly RV Makeover: How to Change Outdated RV Lighting