Can I Put Conspicuity Reflective Tape on Diamond Pattern Steel Plate
Updated 09/19/2021 | Published 09/18/2021
Question:
Does this tape or a similar tape work on Diamond steel or aluminum plating the sides and back of my trailer?
asked by: Scott H
0
Expert Reply:
I don't recommend putting the 7" Long White/ 11" Long Red Conspicuity Reflective Tape - (8) 18" Strips # RE18T on diamond plates because it's going to be tough to get it to stick without bubbles everywhere. With that said, it will certainly stick to flat metal surfaces without issue.
expert reply by:
Erik B
0
Product Page this Question was Asked From
7" Long White/ 11" Long Red Conspicuity Reflective Tape - (8) 18" Strips
- Trailer Lights
- Reflectors
- Rectangle
- Surface Mount
- 18L x 2W Inch
- Red
- White
- Optronics
more information >
Continue Researching
- Q&A: Recommended Bolt On 7,000 lbs Capacity Square Jack
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Way To Protect Wires On Trailer Wiring Harness
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Q&A: How to Power Trailer Dome Light When Not Connected to Tow Vehicle
- Q&A: How to Determine Replacement 6,000 lb Leaf Springs For Arctic Wolf 5th Wheel Trailer
- Q&A: Can Patriot Hitches Square Trailer Jack with Reinforced Mount Attach to 6 inch Tall Frame
- Q&A: What is the Bolt Hole Spacing and Diameter of the 2-1/2 Equal-i-zer Weight Dist Shank FA88FR?
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Raise Your Travel Trailer Height
- Article: Bike Racks, Carriers, and Accessories