Is Valterra Waste Valve for RV Gray Water Tank w/ Cap # T1001C ABS or PVC

Question

Question:

Is this constructed of ABS plastic or PVC?

asked by: Colin G

0

Expert Reply:

The Valterra Waste Valve for RV Gray Water Tank w/ Cap # T1001C that you referenced is made of ABS plastic.

expert reply by: Jameson C

0

Answer 1

Hello James, I have a great set-up for you. You will want to use the Valterra Gray Water Drain Connector - 1-1/2" FPT to 3/4" Hose Thread #T01-0094VP, or if you need a 90 degree option, the Valterra Gray Water Drain Connector - 1-1/2"…

view full answer...

Answer 2

The double valve you need to install on the 3-inch waste pipe in the photo is part #T84. This is the female valve designed to fit over a 3-inch pipe. To cap the 3-inch line you would need part #T50B. This is a waste valve that comes with a 3-inch…

view full answer...

Answer 3

If you have the Valterra Waste Valve for RV Gray Water Tank, #T1001C installed to your 1-1/2" sewer pipe and this valve is then attached to a Valterra gray water drain adapter, #T01-0091VP, then to a garden hose, yes, I can see that you are…

view full answer...

Answer 4

In order to drain your gray water tank with the Valterra #T1001C, which has a 1-1/2" MPT end threads onto sewer system pipe, you'll want to use the Valterra Gray Water Drain Connector - 90-Degree - 1-1/2" FPT to 3/4" MPT…

view full answer...

Answer 5

We do have an option for a drain hose to be used with the Valterra Waste Valve for RV Gray Water Tank w/ Cap #T1001D. When installing the Valterra Waste Valve for RV Gray Water Tank w/ Cap #T1001D, you will want to use some Valterra ABS Solvent…

view full answer...

Answer 6

The standard size of a water drain valve for grey tanks on most RV's is 1-1/2". For this 1-1/2" drain valve, I have three options for you to consider. The first option is the Valterra Waste Valve for RV Gray Water Tank part #T1001PBC.…

view full answer...

Answer 7

The Valterra RV Waste Valve, part #T1001B has an inside diameter of 1.9 inches and the outside of the port measures 2.37 inches. I went to our warehouse and measured the waste valve for you. I have attached a photo of the valve with the dimensions…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Is Valterra Waste Valve for RV Gray Water Tank w/ Cap # T1001C ABS or PVC

Product Page this Question was Asked From

Continue Researching