bing tracking image
Q & A Icon

Troubleshooting Lippert Stabilizer Jack That Was Over Loaded  

Published 08/19/2021

Products Featured in This Question



Question:

Where are the fuses to check on the back leveler motor. We put too much pressure on it and it acts like a blown fuse. Thank you

0

Expert Reply:

If you have a stabilizer system like Lippert High-Speed Power Stabilizer Jack # LC298707, then you should be able to check out the attached wiring diagram to verify where the fuse and breaker should be. The breaker is inline of the red wire in between the motor and switch; if you need a new breaker then you can use Replacement 6-Amp Auto Reset Breaker # LC134181. The fuse is inline of red wire between the battery and the switch; replace with fuse of same rating if fuse is blown.

If you cannot get the system working properly then let me know and I will look more into the issue to see if your motor could potentially be faulty.

expert reply by:
0
Andrew N
Lippert Stabilizer Jack Diagram
Lippert Stabilizer Jack Diagram
(click to enlarge)

Video/Article/FAQ this Question was Asked From

Article or Video
Q & A Icon

Continue Researching

See More Q&A Expert Answers >>